Each unit can control 3 blinds or 6 switched devices

Depending on how you configure the unit it can control either three changeover/flip-flop devices such as blinds or six individual relays.
Up to 15 units can be chained together from one serial port.  Chaining the units allows up to 45 individual blinds to be controlled from a single serial port on the controller.  Chanining also allows macros to control multiple blinds.

Drivers included for each relay type

As well as the main controller driver, drivers are included for generic flip-flop devices, single relays and a specific blinds module.  This ensures the correct icons are displayed on the Control4 interfaces.

Tilt commands supported for blinds

The controller provides two 'tilt' positions for blinds.  Whilst these are not shown on the Control4 interfaces these commands are available via custom programming and could be added to custom buttons.

Single command to control all blinds

Device specific commands are available to control all the linked blinds as one.  This can be all the units or the first nine controllers in the system.  

Can send macros to relay system

The Control Master 3 can be programmed to respond to macro commands.  So you can define a command 'AllUp' which is associated with the Up command on chained units.  Then when the 'AllUp' command is sent all the blinds will simultaneously move up.  This feature is available as a Control4 Device Specific Command in Custom Programming.

Requirements

The driver has only been tested with Control4 OS 2.x and we do not gurantee it will work with older versions of Control4.